Configurazione di Windows Vista per Smart DNS Proxy

Seguire le istruzioni di configurazione è necessario solo una volta. Una volta terminato il setup iniziale, non sarà necessario eseguire gli stessi passi in qualsiasi momento. La vostra connessione funzionerà automaticamente in qualsiasi momento!

1. 2.Cliccare sul pulsante Start e cliccare su Pannello di controllo.

2. 2.Cliccare su Rete e Internet.

3. 3.Cliccare su Rete e condivisione.

4. 4.Fare clic su Gestisci connessioni di rete.

5. Double Click on Your Connected Network Adapter.
Important: Make sure to select the network adapter your PC is using to connect the Internet. If you are using wireless, then select any connected wireless adapter. You should see connected adapter as coloured and not connected with red cross dimmed coloured.

6. 7.Cliccare su Proprietà.

7. Uncheck the Internet Protocol Version 6 (TCP/IPv6).

Then Click on Internet Protocol Version 4 (TCP/IPv4) and then Click on Properties.

8. From the General Tab Click on Use the following DNS server addresses. 

Fill the DNS fields with Smart DNS Server IPs as following:

Use the closest server to your physical location as Preferred DNS Server. Then use the 2nd closest server to your physical location as Alternate DNS server.

The list of IP addresses of our DNS severs can be found on our DNS Server List here: https://www.smartdnsproxy.com/Servers. 

9. Click on OK and OK again.

Attention

Please make sure to restart your PC now and then visit www.smartdnsproxy.com and LOG INTO your account so that our system could identify your IP address to work with Smart DNS Proxy services. Otherwise, our service will not work.